
Cemimax DP400
2K Epoxy Resin Moisture Vapor Retarder and Surface Hardening Primer
Cemimax DP400 is a 2-component solvent-free epoxy primer and bonding agent. Designed for use with Cemimax self-leveling underlayment and polishable overlays as a sand broadcast carrier using #30 sand. DP400 is used when there is worry about the subfloor you are bonding with.
Products Features and Benefits
- Bridges cracks
- Moisture control up to 100% RH
- Increase the strength of the substrate
- Very good resistance to chemical
- Excellent covering and filling capacity
- Solvent free
Technical Data
(Under normal conditions at 20℃.)
- Packaging: Metal can
- Packsize: 12 kg by Set
- Shelf-life: 12 months
- Working temperature: Min. 5-30℃ at floor level
- Consumption: 300-600g/㎡ *
- Drying time: 12-24 hours by foot traffic
- Pot life: 25-30 minutes
- Mixing ratio: A:B = 1:2
- Working time: 2 hours
Limitations and Important Notes
The product should be protected against frost and direct light during transportation, storage and application. Application temperature should not be lower than 5℃.
Suitable Substrate Conditions
- A vapor retarder for use up to 100 % RH on scarified, very dense or smooth concrete
- Properly prepared epoxy coatings, ceramic tile, terrazzo and VCT
- Properly prepared sound and stable concrete substrates, both smooth and nonabsorbent as well as absorbent or profiled
- Use on cracked substrates as repair resin
Application
- All surfaces should be structurally sound, dry, solid and stable.
- Clean surface to remove any contaminant bond breaking materials such as sealers, wax, oil and dirt.
- If mechanically polishing surface should be profiled using a grinder or bead blaster.
- After mixing A and B components stir the materials fully.
- Apply the primer evenly to fully cover the surface using a fine-pored foam roller cross-strokes
- Broadcast quartz sand (70-140#) to refusal while primer surface is wet.
- Use as moisture vapor retarder must be installed at a uniform layer thickness of at least 30 mils (0.1 perms). After application immediately at a back roll material (90 degrees to the direction of squeege / trowel coat) using an Nylon Fiber Roller pre-saturated in DP400 solution.
- Allow to dry for 16-24 hours then vacuum loose sand. Apply leveling compound.